Ok it wasn’t my design the problem, same problem for me I have lost 5 OSD (shortcut 5V GND).
And now I’m waiting for another chips from my distributor
I use this oven for prototype
peak 240°c
The chips OSD are very expensive and not available (mouser, digi-key…), not easy for prototyping
Best regards
Alexandre
You can see a ball of solder gets out from component.
What type of solder is used in the chip? Low Temperature?
5V and GND are in shortcut
I find the problem, you need to “save as” again the project before generate code.
“save as” modifies the device tree root location with the good location
Alexandre
Hi,
I have the same issue with STM32CubeMX(6.1.1) and STM32Cube FW_MP1 V1.3.0 package.
Kevin, have you find the solution?
Kind regards
Alexandre
Octavo Systems LLC all rights reserved
OCTAVO is registered in the U.S. Patent and Trademark Office. OSD, C-SiP, and the Octavo Logo are trademarks of Octavo Systems LLC.
"*" indicates required fields
"*" indicates required fields
"*" indicates required fields
"*" indicates required fields