[Akshay]

Thanks Neeraj,
I will try that out. Thank you for your support.
Warm Regards,
Akshay

[Akshay]

Hi Erik,
We tried modifying the device tree using CubeMx but we are unable to set the otg function to the pin DP1 and DM1. If we manually change the device tree and build it will it work? Also in the block diagram for the usb connection those pins are specified as usb host. So I was wondering if it would work? I have attached the block diagram below.
Thanks,
Akshay

Attachments:

1. 

   otg_block.jpeg
   

[Akshay]

Thanks Erik,
I’ll try it and give you the feedback. Also we have added a wifi driver (NINA-132) which communicates with the sip via UART. Do we need to write wifi driver code for initializing it?
Regards,
Akshay

[Akshay]

Thanks Erik,
I’ll try it and give you the feedback. Also we have added a wifi driver (NINA-132) which communicates with the sip via UART. Do we need to write wifi driver code for initializing it?
Regards,
Akshay

• This reply was modified 3 years, 10 months ago by Akshay.

[Akshay]

Thanks Neeraj,
I am trying to interface a wifi module with brk board usng UART. Do i need to write a wifi driver for the STLinux?
Regards,
Akshay

[Akshay]

Thanks @Neeraj Dantu.
The compilation was successful.But when I flash the U-Boot from my cubemx project the BRK board doesn’t seem to boot up. If i use the device tree for u-boot from the link:
https://github.com/octavosystems/OSD32MP1-BRK-device-tree/tree/master/u-boot-v2020.01 the board seems to boot fine. Is it ok if i use this u-boot file along with my custom kernel device tree?
Regards,
Akshay

[Author]

Posts