512-861-3400Log inCreate Account

CANBUS CAPE

Forums › Reference, Evaluation, and Development Boards › OSD3358-SM-RED › CANBUS CAPE

Viewing 1 reply thread
  • Author
    Posts
    • June 6, 2018 at 1:59 pm #5614
      Gary Brackgbrack
      Participant

        Can anybody recommend a CAPE module with either CANFD or CAN bus that works with the OSD3358-SM-RED board?

      • June 6, 2018 at 4:42 pm #5616
        Neeraj Kumar Reddy DantuNeeraj Dantu
        Moderator

          G,

          There are more than one ways to prototype with CAN bus.

          1. BeagleboneBlue comes with a CAN PHY on board(https://beagleboard.org/blue)

          2. You can use a CAN evaluation module(ex: http://www.ti.com/tool/tcan1042devm) and wire it up to RED board

          3. There are several DIY solutions. A couple are linked below, but not tested by Octavo:

          – http://www.thomas-wedemeyer.de/beaglebone-canbus-python.html

          – http://www.instructables.com/id/DIY-Beaglebone-CAN-Bus-Cape/

          Hope that helps

      • Author
        Posts
      Viewing 1 reply thread
      • You must be logged in to reply to this topic.

      Octavo Systems LLC all rights reserved
      OCTAVO is registered in the U.S. Patent and Trademark Office. OSD, C-SiP, and the Octavo Logo are trademarks of Octavo Systems LLC.