poweroff command line issue

Forums Devices OSD32MP15x poweroff command line issue

Viewing 2 reply threads
  • Author
    Posts
    • #11839
      damien brayeldam_fr
      Participant

        Hello Octavo Teams!

        We’re testing another one stm32MP1 custom board (battery powered), and i’ve issue with poweroff command line function:
        Each time i use this function, board is rebooting instead of poweroffing (…)

        With these info from tfa:
        INFO: Reset reason (0x814):
        INFO: Pad Reset from NRST

        I’ve see a similar post on ST Forum, but i doesn’t help me!

        We are using a STM32MP1 from your Octavo partner, and i will post on their forum too.
        Octavo have encapslulated STM32MP1+PMIC+DDR on a single chip, so PMIC should be correctly wired.

        We have a PONKEY wired on the board, witch works perfectly, i can shutdown and wakeup by an action on “power” button.

        I’ve tried lot of distribution configuration, looked at PMIC internal registry, but i’ve no hints on what cause this.

        I’ve tried to use a “generic” Octavo Distribution (BRK one), stopped booting at uboot, to avoid unnecessary software issue, but i’ve the same behaviour.
        I’m feeling that there is an hardware issue, but i don’t see where it is?

        May someone give me an advice on this problem?

        have a nice day!

        Attachments:
      • #11841
        damien brayeldam_fr
        Participant

          Well, with the help of ST Teams,
          I solved this issue:

          We were using nrst signal for resetting emmc.
          Emmc was powered by +3.3(PMIC_VOUT4).
          During power down sequence, +3.3(PMIC_VOUT4) was shutting down, emmc was not powered and maybe driving nrst low.(maybe)
          If we cut the connection between nrst(pmic) and rst(emmc), i can poweroff my board.

          I have a look on an Octavo’BRK board, monitoring with a scope reset,+3V3,VDDI when poweroff command line issued.
          I was surprised that there is no activity on reset, only +3V3 is shutting down.
          I thinked that after a poweroff command, stpmic put stmp2MP1 in reset state(assert nrst) and then shut-off power line.
          Anyway, board works now..

        • #11843
          Neeraj Dantu
          Moderator

            eldam_fr,

            Thanks for the update on this issue. We are glad you were able to determine the root cause.

            Best,

            Neeraj

        Viewing 2 reply threads
        • You must be logged in to reply to this topic.