Issues booting from USB
Forums › Reference, Evaluation, and Development Boards › OSD32MP1-RED › Issues booting from USB
- This topic has 2 replies, 2 voices, and was last updated 3 years, 5 months ago by
Manuel Malagon.
- AuthorPosts
- June 18, 2021 at 2:41 pm #11636
I was following OSD32MP1 Debian SDK guide and I have issues with my board. I have configured the boot switch to all 0’s (all levers down) but I get this when running the STM32_Programmer_CLI -l USB command:
1234567-------------------------------------------------------------------STM32CubeProgrammer v2.6.0-------------------------------------------------------------------===== DFU Interface =====No STM32 device in DFU mode connectedAnd I don’t know why. Could my board be damaged? but how? I can boot just fine from an SDCard and I measured the voltages in the switch and they are all 0’s so I know that’s working right.
Any ideas?
- June 21, 2021 at 10:27 am #11638
Manuel,
Here are some steps you can take to debug this issue:
1. To verify that the hardware works, see if the RNDIS functionality works when you boot up Linux. You should see an extra virtual Ethernet interface
2. Try a different board such as the BRK, DK2 or EV1.
3. Change your USB cable.
4. Check whether you have all the device rules installed for your Cube Programmer software.
A couple of threads that may be interesting: https://community.st.com/s/question/0D53W000000aP9J/no-stm32-device-in-dfu-mode-connected and https://community.st.com/s/question/0D53W00000LCUHa/no-stm32-device-in-dfu-mode-connected.
Best,
Neeraj
- June 22, 2021 at 9:47 am #11639
Neeraj,
Awesome! Thank you so much for helping!
It turns out it was the udev rules! I followed the instructions in the community post you mentioned and now it is working!
Regards,
Manuel Malagon
- AuthorPosts
- You must be logged in to reply to this topic.