CubeMX Project for BRK
Forums › Reference, Evaluation, and Development Boards › OSD32MP1-BRK › CubeMX Project for BRK
- This topic has 4 replies, 2 voices, and was last updated 3 years, 6 months ago by
Akshay.
- AuthorPosts
- March 19, 2021 at 3:39 am #11376
Hi Team,
I have modified the the minimal config project in CubeMX and generated the device trees for the kernel,uboot and TF-A. How do I compile these files and add it to the developer package so that it works on the BRK board.
Regards ,
Akshay
- March 23, 2021 at 4:25 pm #11382
Akshay,
The procedure to compile custom device trees with the Developer Package is shown here: https://wiki.st.com/stm32mpu/wiki/How_to_compile_the_device_tree_with_the_Developer_Package/.
Best,
Neeraj
- March 27, 2021 at 3:12 am #11388
Thanks @Neeraj Dantu.
The compilation was successful.But when I flash the U-Boot from my cubemx project the BRK board doesn’t seem to boot up. If i use the device tree for u-boot from the link:
https://github.com/octavosystems/OSD32MP1-BRK-device-tree/tree/master/u-boot-v2020.01 the board seems to boot fine. Is it ok if i use this u-boot file along with my custom kernel device tree?
Regards,
Akshay - March 29, 2021 at 12:50 pm #11390
Akshay,
That should work as long as you have all the features you need in U-Boot. Please check the SD card detect declaration in CubeMX generated device tree and make sure that it is the same pin as the CD pin connected in the BRK schematics. I suspect this is preventing the board boot.
Best,
Neeraj
- April 22, 2021 at 2:39 am #11460
Thanks Neeraj,
I am trying to interface a wifi module with brk board usng UART. Do i need to write a wifi driver for the STLinux?
Regards,
Akshay
- AuthorPosts
- You must be logged in to reply to this topic.