U-Boot 2018.01-dirty (Sep 10 2018 - 11:45:06 +0200) CPU : AM335X-GP rev 2.1 I2C: ready DRAM: 512 MiB No match for driver 'omap_hsmmc' No match for driver 'omap_hsmmc' Some drivers were not found Reset Source: Power-on reset has occurred. MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 Using default environment not set. Validating first E-fuse MAC BeagleBone: cape eeprom: i2c_probe: 0x54: BeagleBone: cape eeprom: i2c_probe: 0x55: BeagleBone: cape eeprom: i2c_probe: 0x56: BeagleBone: cape eeprom: i2c_probe: 0x57: Net: usb_ether Press SPACE to abort autoboot in 2 seconds board_name=[A335BLNK] ... switch to partitions #0, OK mmc0 is current device SD/MMC found on device 0 ** Bad device 0:2 0x82000000 ** ** Bad device 0:2 0x82000000 ** switch to partitions #0, OK mmc0 is current device Scanning mmc 0:1... gpio: pin 56 (gpio 56) value is 0 gpio: pin 55 (gpio 55) value is 0 gpio: pin 54 (gpio 54) value is 0 gpio: pin 53 (gpio 53) value is 1 switch to partitions #0, OK mmc0 is current device gpio: pin 54 (gpio 54) value is 1 Checking for: /uEnv.txt ... Checking for: /boot.scr ... Checking for: /boot/boot.scr ... Checking for: /boot/uEnv.txt ... gpio: pin 55 (gpio 55) value is 1 2086 bytes read in 73 ms (27.3 KiB/s) Loaded environment from /boot/uEnv.txt Checking if uname_r is set in /boot/uEnv.txt... gpio: pin 56 (gpio 56) value is 1 Running uname_boot ... loading /boot/vmlinuz-4.14.49-ti-r54 ... 10453504 bytes read in 911 ms (10.9 MiB/s) unable to find [dtb=am335x-boneblack-emmc-overlay.dtb] did you name it correctly? ... FAILSAFE: U-Boot UMS (USB Mass Storage) enabled, media now available over the usb slave port ... Unknown command 'ums' - try 'help' uboot_overlays: [fdt_buffer=0x60000] ... uboot_overlays: loading /lib/firmware/AM335X-PRU-RPROC-4-14-TI-00A0.dtbo ... 3513 bytes read in 656 ms (4.9 KiB/s) libfdt fdt_check_header(): FDT_ERR_BADMAGIC No FDT memory address configured. Please configure the FDT address via "fdt addr
" command. Aborting! No FDT memory address configured. Please configure the FDT address via "fdt addr
" command. Aborting! No FDT memory address configured. Please configure the FDT address via "fdt addr
" command. Aborting! loading /boot/initrd.img-4.14.49-ti-r54 ... 4247817 bytes read in 413 ms (9.8 MiB/s) debug: [console=ttyO0,115200n8 root=/dev/mmcblk0p1 ro rootfstype=ext4 rootwait coherent_pool=1M net.ifnames=0 quiet] ... debug: [bootz 0x82000000 0x88080000:40d109 0x88000000] ... ERROR: Did not find a cmdline Flattened Device Tree Could not find a valid device tree ** Invalid partition 2 ** ** Invalid partition 3 ** ** Invalid partition 4 ** ** Invalid partition 5 ** ** Invalid partition 6 ** ** Invalid partition 7 ** Card did not respond to voltage select! mmc_init: -95, time 12 gpio: pin 56 (gpio 56) value is 0 gpio: pin 55 (gpio 55) value is 0 gpio: pin 54 (gpio 54) value is 0 gpio: pin 53 (gpio 53) value is 1 Card did not respond to voltage select! mmc_init: -95, time 13 gpio: pin 54 (gpio 54) value is 1 Card did not respond to voltage select! mmc_init: -95, time 13 ** Bad device mmc 1 ** Checking for: /uEnv.txt ... Card did not respond to voltage select! mmc_init: -95, time 13 ** Bad device mmc 1 ** Checking for: /boot.scr ... Card did not respond to voltage select! mmc_init: -95, time 13 ** Bad device mmc 1 ** Checking for: /boot/boot.scr ... Card did not respond to voltage select! mmc_init: -95, time 13 ** Bad device mmc 1 ** Checking for: /boot/uEnv.txt ... Card did not respond to voltage select! mmc_init: -95, time 13 ** Bad device mmc 1 ** Card did not respond to voltage select! mmc_init: -95, time 12 ** Bad device mmc 1 ** Card did not respond to voltage select! mmc_init: -95, time 12 ** Bad device mmc 1 ** Card did not respond to voltage select! mmc_init: -95, time 13 ** Bad device mmc 1 ** Card did not respond to voltage select! mmc_init: -95, time 13 ** Bad device mmc 1 ** Card did not respond to voltage select! mmc_init: -95, time 13 ** Bad device mmc 1 ** Card did not respond to voltage select! mmc_init: -95, time 12 ** Bad device mmc 1 ** starting USB... USB0: Port not available. using musb-hdrc, OUT ep1out IN ep1in STATUS ep2in MAC 98:5d:ad:50:ed:59 HOST MAC de:ad:be:af:00:00 RNDIS ready